Figure 43. Removing a cabled drive
Next steps
1. Follow the procedure listed in
After working inside your system
.
2. Install the internal drive bay into the chassis.
3. If disconnected, reconnect the power and data cable(s) to the remaining drive(s) in the internal drive bay.
Installing a cabled drive
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
Before working inside your system
3. Remove the internal drive bay.
Steps
1. Insert the drive into the internal drive bay with the drive connector facing outward.
2. Secure the drive to the internal drive bay using the four screws.
NOTE:
When installing new drives into the internal drive bay, use the spare drive screws attached to the drive bay.
Installing and removing system components
55
