Power-button board
Removing the power-button board
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
4. Remove the
.
5. Remove the
.
6. Remove the
7. Remove the
.
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
Steps
1. Open the latch, and disconnect the power-button board cable from the connector on the system board.
2. Unroute the power-button board cable from the display-assembly base.
3. Remove the screw (M3x5) that secures the power-button board to the middle frame.
4. Lift and remove the power-button board with the cable off the middle frame.
Installing the power-button board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
60
Removing and installing components