About this task
The following image indicates the location of the power-button board and provides a visual representation of the installation
procedure.
Steps
1. Align and place the power-button board in the slot on the middle frame.
2. Replace the screw (M3x5) to secure the power-button board to the middle frame.
3. Route the power-button board cable through the display-assembly base.
4. Connect the power-button board cable to the connector on the system board and close the latch to secure the cable.
Next steps
1. Install the
.
2. Install the
3. Install the
.
4. Install the
5. Install the
6. Install the
7. Install the
.
After working inside your computer
.
Microphones
Removing the microphones
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
4. Remove the
.
5. Remove the
.
Removing and installing components
61