Steps
1. Gently pry the P-sensor board from its slot on the display back cover.
2. Flip over the P-sensor board.
3. Disconnect the display cable from the P-sensor board.
4. Remove the P-sensor board.
Installing the P-sensor board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the P-sensor board and provides a visual representation of the installation procedure.
110
Removing and installing components
Summary of Contents for OptiPlex 7760
