Steps
1. Carefully route the keyboard FPC and keyboard backlight FPC through the inner frame and place the inner frame on the
computer chassis.
2. Replace the ten (M2x3) screws to secure the inner frame in place.
3. Route the WLAN and WWAN antenna cables through the routing guide.
4. For the computers shipped with WWAN card:
a. Connect the two Darwin antenna cables to the connector on the system board.
b. Align and place the Darwin bracket to secure the Darwin antenna cables to the system board.
c. Replace the (M2x3) screw to secure the Darwin bracket in place.
Next steps
1. Install the
2. Install the
.
3. Install the
.
4. Install the
.
5. Install the
.
6. Install the
.
after working inside your computer
.
50
Removing and installing components
Summary of Contents for OptiPlex 7760
