About this task
The figure indicates the location of the touchpad buttons and provides a visual representation of the removal procedure.
Steps
1. For models shipped with smart card reader, disconnect the smart card reader FFC from the USH daughter board and peel
the smart card reader FFC from the touchpad.
2. Disconnect the touchpad buttons FPC from the connector on the touchpad.
3. Remove the two (M2x2.5) screws that secure the touchpad buttons to the palmrest.
4. Remove the touchpad buttons from the palmrest.
Installing the Touchpad buttons
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the touchpad buttons and provides a visual representation of the installation procedure.
Removing and installing components
53
Summary of Contents for OptiPlex 7760
