Steps
1. Open the display assembly to a 45-degree angle and place the computer at the edge of a flat table so that the display
assembly can extend below the table.
NOTE:
For computers shipped with IR camera configuration, disconnect the display cable and IR camera cable.
2. Peel and remove the WWAN cables and the Darwin cables from the palmrest.
3. Remove the eight (M2.5x2.5) screws that secure the hinges to the palmrest.
4. Remove the display assembly from the palmrest.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the installation procedure.
88
Removing and installing components
Summary of Contents for OptiPlex 7760
