Steps
1. Place the touchpad buttons into its slot in the palmrest.
2. Replace the two (M2x2.5) screws to secure the touchpad buttons to the palmrest.
3. Connect the touchpad buttons FPC to the connector in the touchpad.
4. For models shipped with smart card reader, connect the smart card reader FFC to the USH daughter board and adhere the
smart card reader FFC on the touchpad.
Next steps
1. Install the
.
2. Install the
3. Install the
.
4. Install the
.
5. Install the
.
6. Install the
.
7. Install the
.
after working inside your computer
.
SD card reader
Removing SD card reader
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
.
6. Remove the
7. Remove the
8. Remove the
.
9. Remove the
.
10. Remove the
.
54
Removing and installing components
Summary of Contents for OptiPlex 7760
