Removing and Replacing Parts on the Mini Tower Chassis
6-19
6\VWHP%RDUG
)LJXUH6\VWHP%RDUG5HPRYDO
To remove the system board, follow these steps:
'LVFRQQHFWDOOFDEOHVIURPWKHLUFRQQHFWRUVDWWKHEDFNRIWKH
FRPSXWHU
5HPRYHWKHH[SDQVLRQFDUGFDJH
'LVFRQQHFWDOOFDEOHVIURPWKHV\VWHPERDUG
5HPRYHWKHVFUHZWKDWVHFXUHVWKHV\VWHPERDUGWRWKHERWWRPRI
WKHFKDVVLV
6OLGHWKHV\VWHPERDUGWRZDUGWKHIURQWRIWKHFKDVVLVXQWLOLW
VWRSV
&DUHIXOO\OLIWWKHV\VWHPERDUGRXWRIWKHFKDVVLVEHVXUHWROLIW
HYHQO\DQGQRWWZLVWWKHV\VWHPERDUG
NOTES: If you are replacing the system board, remove all DIMMs, the video-
memory upgrade module (if present), the single-edge contact (SEC) cartridge/
heat sink assembly, and the guide bracket assembly from the old system
board and install them on the replacement board. Also, set the jumpers on the
new system board so that they are identical to those on the old board, unless a
microprocessor upgrade is being installed.
If the original system board has a NIC connector, ensure that the replacement
board has a NIC connector.
When you reinstall the system board (before you slide the system board back
to lock it in position), push down near each slot to engage the grounding clip
screw
slots (5)
tabs (5)
Summary of Contents for OptiPlex G1
