Replacing the touchpad
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
. After working inside your computer, follow
the instructions in
After working inside your computer
. For more safety best
practices, see the Regulatory Compliance home page at
.
Procedure
1
Align the screw holes on the touchpad with the screw holes on the palm-rest
assembly.
2
Replace the four screws (M2x2) that secure the touchpad to the palm-rest
assembly.
3
Slide the touchpad cable into the connector on the system board and close the
latch to secure the cable.
4
Route the touchpad cable and adhere the cable to the keyboard and palm-rest
assembly.
Post-requisites
1
Replace the
.
2
Replace the
.
46
