PowerConnect B-MLXe Hardware Installation Guide
91
53-1002111-01
Chapter
4
Connecting a Router to a Network Device
Assigning permanent passwords
DANGER
The procedures in this manual are for qualified service personnel.
By default, the CLI is not protected by passwords. To secure CLI access, it is strongly recommended
that you assign passwords.
The CLI contains the following access levels:
•
Privileged EXEC – This level is also called the Enable level and can be secured by a password.
From this level you can manage files on the management module flash memory or a PCMCIA
flash card in the management module slots 1 or 2, save the system configuration to flash
memory, and clear caches.
•
CONFIG – The configuration level. From this level you can configure a system IP address and
configure routing features. To access the CONFIG mode, you must already be logged into the
Privileged level of the EXEC mode.
NOTE
You cannot assign a password using the Web management interface. You can assign passwords
using the SNMP Network Manager software if an Enable password for a super user is already
configured on the device.
You can set the following levels of Enable passwords:
•
Super user – Allows complete read-and-write access to the system. This is generally for system
administrators and is the only password level that allows you to configure passwords.
NOTE
You must set a super-user password before you can set other types of passwords.
•
Port configuration – Allows read-and-write access for specific ports but not for global
(system-wide) parameters.
•
Read only – Allows access to the Privileged EXEC mode and CONFIG mode but only with read
access.
To set passwords, perform the following steps.
1. At the opening CLI prompt, enter enable to change to the Privileged level of the EXEC mode.
NetIron> enable
NetIron#
2. Access the CONFIG level of the CLI by entering the configure terminal command.
Summary of Contents for PowerConnect B - MLXe 16
Page 1: ...53 1002111 01 02 November 2010 PowerConnect B MLXe Hardware Installation Guide ...
Page 194: ...182 PowerConnect B MLXe Hardware Installation Guide 53 1002111 01 Power cords 8 ...
Page 198: ...186 PowerConnect B MLXe Hardware Installation Guide 53 1002111 01 Russia A ...
Page 212: ...200 PowerConnect B MLXe Hardware Installation Guide 53 1002111 01 Dangers B ...
