802.1x Commands
303
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\802.1X.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 5/ 1 5 /1 2 - F O R PR O O F O N LY
dot1x timeout supp-timeout
Use the
dot1x timeout supp-timeout
Interface Configuration (Ethernet)
mode command to set the time interval during which the device waits for a
response to an Extensible Authentication Protocol (EAP) request frame from
the client before resending the request. Use the
no
form of this command to
restore the default configuration.
Syntax
dot1x timeout supp-timeout
seconds
no dot1x timeout supp-timeout
Parameters
seconds
—Specifies the time interval in seconds during which the device waits
for a response to an EAP request frame from the client before resending the
request. (Range: 1–65535 seconds)
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust to
unusual circumstances, such as unreliable links or specific behavioral
problems with certain clients and authentication servers.
Example
The following example sets the time interval during which the device waits
for a response to an EAP request frame from the client before resending the
request to 3600 seconds.
Console(config)#
interface
gigabitethernet
1/0/15
Console(config-if)#
dot1x timeout supp-timeout
3600
