Dell PowerConnect W-AirWave 7.4
| User Guide
Configuring and Using Device Groups in AirWave |
83
3. Select Save to retain these security configurations for the group, select Save and Apply to make the changes
permanent, or select Revert to discard all unapplied changes.
4. Continue with additional security-related procedures in this document for additional RADIUS and SSID
settings for device groups, as required.
Configuring Group SSIDs and VLANs
The Groups > SSIDs configuration page allows you to create and edit SSIDs and VLANs that apply to a device
group. Perform these steps to create or edit VLANs and to set SSIDs.
Authentication Profile
Name
AMP-
Defined
Server #1
For Proxim devices only, this field sets the name of the authentication profile to be
supported in this device group.
Authentication Profile
Index
1
For Proxim devices only, this field sets the name of the authentication profile index
to be supported in this device group.
RADIUS Accounting Servers Section
RADIUS Accounting Server
#1 - #4
Not selected Defines one or more RADIUS Accounting servers to be supported in this device
group. Select up to four RADIUS accounting servers from the four drop-down
menus.
Authentication Profile
Name
For Proxim devices only, this field sets the name of the accounting profile to be
supported in this device group.
Authentication Profile
Index
3
For Proxim devices only, this field sets the name of the accounting profile index to
be supported in this device group.
MAC Address Authentication Section
MAC Address
Authentication
No
If enabled, only MAC addresses known to the RADIUS server are permitted to
associate to APs in the Group.
MAC Address Format
Single Dash
Allows selection of the format for MAC addresses used in RADIUS authentication
and accounting requests:
Dash Delimited: xx-xx-xx-xx-xx-xx (default)
Colon Delimited: xx:xx:xx:xx:xx:xx
Single-Dash: xxxxxx-xxxxxx
No Delimiter: xxxxxxxxxxxx
This option is supported only for Proxim AP-600, AP-700, AP-2000, AP-4000, Avaya
AP3/4/5/6/7/8, HP ProCurve 520WL
Authorization Lifetime
1800
Sets the amount of time a user can be connected before reauthorization is required.
The supported range is from 900 to 43,200 seconds.
Primary RADIUS Server
Reattempt Period
0
Specifies the time (in minutes) that the AP awaits responses from the primary
RADIUS server before communicating with the secondary RADIUS server, and so
forth
Table 55
Groups > Security Page Fields and Default Values (Continued)
Setting
Default
Description
NOTE: WLANs that are supported from one or more Cisco WLC controllers can be configured on the Groups > Cisco WLC Config
page.
Summary of Contents for PowerConnect W-Airwave
Page 1: ...Dell PowerConnect W AirWave 7 4 User Guide ...
Page 106: ...106 Configuring and Using Device Groups in AirWave Dell PowerConnect W AirWave 7 4 User Guide ...
Page 256: ...256 Creating Running and Emailing Reports Dell PowerConnect W AirWave 7 4 User Guide ...
Page 310: ...310 Index Dell PowerConnect W AirWave 7 4 User Guide ...