Dell PowerConnect W-AP130 Series Access Point
| Installation Guide
7
Figure 4
Mounting the AP
7. On the W-AP134, install the external antennas according to the manufacturer’s instructions, and connect the
antennas to the antenna interfaces on the AP.
Connecting Required Cables
Install cables in accordance with all applicable local and national regulations and practices.
Ethernet Ports
The RJ45 Ethernet ports (ENET0 and ENET1) support 10/100/1000Base-T auto-sensing MDI/MDX
connections. Use these ports to connect the AP to a twisted pair Ethernet LAN segment or directly to a Dell
Controller. Use a 4- or 8-conductor, Category 5 UTP cable up to 100 m (325 feet) long.
The 10/100/1000 Mbps Ethernet ports are on the bottom of the AP. These ports have RJ-45 female connectors
with the pin-outs shown in
Table 1
.
Table 1
Ethernet Port Pin-out
Connector
Pin
Signal
Name GE Connection
FE
Connection
PoE
1
BI_DA+ Bi-directional pair A+
RX+
POE negative
2
BI_DA– Bi-directional pair A–
RX–
POE negative
3
BI_DB+ Bi-directional pair B+
TX+
POE positive
4
BI_DC+ Bi-directional pair C+
Spare pair
POE positive
5
BI_DC– Bi-directional pair C–
Spare pair
POE positive
6
BI_DB– Bi-directional pair B–
TX–
POE positive
7
BI_DD+ Bi-directional pair D+
Spare pair
POE negative
8
BI_DB– Bi-directional pair D–
Spare pair
POE negative
AP-130_002
1
2
3
4
5
6
7
8
