Installing System Components | 169
10
Replace the four screws that secure the LSI 9265-8i card assembly.
11
Install the system-board assembly. See "Installing a System-Board
Assembly" on page 143.
Cable Routing for LSI 9265-8i Card (1U Node)
1
Connect the mini-SAS cable to the LSI 9265-8i card, and connect the
other end of the cable to the corresponding connector on the system
board.
2
Connect the mini-SAS&SGPIO cable to the LSI 9265-8i card, and
connect the other end of the cable to the corresponding connectors on
the system board. Ensure the cables should go through the cable clip
ring. See Figure 3-24.
3
Connect the RAID battery cable to the BBU interposer card on the LSI
9265-8i card, and connect the other end of the cable to the
corresponding connector on the RAID battery.
NOTE: When connecting the RAID battery cable, the BBU interposer card
should be installed on the LSI 9265-8i card. The BBU interposer card in the
figure below is just for you reference.