268
|
Installing System Components
drive cage. See Figure 3-93.
4
Replace the hard-drive cage into the chassis. See Figure 3-84.
5
Replace the screws that secure the front-panel assemblies to the chassis.
See Figure 3-84.
6
Replace the screws that secure the hard-drive cage to the chassis. See
Figure 3-83.
7
Connect front panel cables to the power distribution board. See Figure
3-96 or Figure 3-99.
You must route these cables properly on the chassis to prevent them
from being pinched or crimped.
8
Connect all the cables to the backplane. See Figure 3-81 for 3.5-inch
hard drives and Figure 3-82 for 2.5-inch hard drives.
You must route these cables properly on the chassis to prevent them
from being pinched or crimped.
9
Close the system. See “Closing the System” on page 219.
10
Replace the hard drives. See “Installing a Hard Drive into a Hard-Drive
Carrier” on page 138.
11
Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.