Running the System Diagnostics
129
Using the Custom Test Options
When you select
Custom Test
in the
Main
Menu
window, the
Customize
window allows you to select the device(s) to be tested, select specific options
for testing, and view the test results.
Selecting Devices for Testing
The left side of the
Customize
window lists
devices that can be tested. Click
(+)
next to a device or module to view its components. Click
(+)
on any
component to view the tests that are available. Clicking a device, rather than
its components, selects all of the components of the device for testing.
NOTE:
After you select all the devices and components that you want to test,
highlight All Devices and then click Run Tests.
Selecting Diagnostics Options
From the
Diagnostics Options
area, select the test(s) you want to run on a
device. You can select:
•
Non-Interactive Tests Only
—Runs only tests that require no user
intervention.
•
Quick Tests Only
—Runs only the quick tests on the device.
•
Show Ending Timestamp
—Time stamps the test log.
•
Test Iterations
—Selects the number of times the test is run.
•
Log output file pathname
—Enables you to specify the USB memory key
where the test log file is saved. You cannot save the file to a hard drive.
Coaster_HOM.book Page 129 Monday, November 3, 2014 3:23 PM
Summary of Contents for PowerEdge T110 II
