48
Installing Enclosure Components
Figure 4-1.
Installing and Removing the Front Bezel
4
To replace the bezel, insert the interlocking notch into the U-shaped handle on the side of the front
enclosure
panel.
5
Snap the left side of the bezel into place in the U-shaped handle on the left side of the
enclosure
.
6
To lock the bezel, insert the key and turn to the right.
Removing and Installing Physical Disks
Your
enclosure
supports up to 15 SAS 3.0-Gbps
physical disk
s, each one contained in its individual disk
carrier. P
hysical disk
s are connected directly to the
enclosure
midplane and are hot-pluggable, allowing you
to remove and insert disks without shutting down your
enclosure
.
This section describes how to remove and install
physical disk
s in your storage array.
NOTICE:
Extra care must be taken when handling and storing the physical disks. The carriers provide some
protection, but the disks and carrier connectors can be damaged by rough handling. When removing the physical
disks from the enclosure, place them on a padded surface. Never drop the disks.
Removing Physical Disks from the Enclosure
NOTICE:
To avoid damage, never leave a physical disk carrier partially removed from the enclosure. Rotating a
carrier handle next to an unseated disk carrier will result in serious damage to the unseated disk carrier.
NOTICE:
To avoid data loss when removing a physical disk, Dell recommends that you verify with MD Storage
Manager that the appropriate disk is being removed. Removing an Assigned physical disk could result in data loss.
1
bezel lock
2
release tab/interlocking notch
3
U-shaped handle
2
1
3
Summary of Contents for PowerVault MD3000
Page 68: ...68 Troubleshooting Your Enclosure ...
Page 100: ...100 Glossary ...
