78
Installing System Components
Installing the Front Bezel
1
Insert the hinge tab on the right of the bezel into the slot on the right side
of the system front panel.
2
Rotate the left side of the bezel toward the system.
3
Press the bezel to the system to engage the latch.
Opening and Closing the System
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
WARNING:
Whenever you need to lift the system, get others to assist you. To
avoid injury, do not attempt to lift the system by yourself.
Opening the System
1
Unless you are installing a hot-swappable component such as a cooling fan
or power supply, turn off the system and attached peripherals, and
disconnect the system from the electrical outlet and peripherals.
2
Rotate the latch release lock counter-clockwise to the unlocked position.
See Figure 3-3.
3
Lift up on the latch on top of the system and slide the cover back. See
Figure 3-3.
4
Grasp the cover on both sides and lift the cover away from the system.
Closing the System
1
Lift up the latch on the cover.
2
Place the cover onto the chassis and offset the cover slightly back so that it
clears the chassis hooks and lays flush on the system chassis. See
Figure 3-3.
3
Push down the latch to lever the cover into the closed position.
4
Rotate the latch release lock in a clockwise direction to secure the cover.
Summary of Contents for PowerVault NX3000
