Installing the keyboard
1.
Press and align the keyboard to its compartment.
2.
Tighten the screws to secure the keyboard to the computer.
3.
Slide the keyboard trim from the front and align it to its position on the computer. Ensure that the
keyboard trim clicks into its place
4.
Connect the keyboard-data cable to the system board.
NOTE: Ensure that you fold the keyboard-data cable in perfect alignment.
5.
Install the:
a.
b.
c.
6.
After working inside your computer
.
Removing the secondary memory
1.
Before working inside your computer
2.
Remove the:
a.
b.
c.
d.
3.
Perform the following steps as shown in the illustration:
a. Remove the screw that secures the memory shield to the computer [1].
b. Lift and remove the memory shield from the computer [2].
c. Pry the retention clips away from the memory module until it pops up [3].
d. Lift the memory module and remove it from the computer [4].
Installing the secondary memory
1.
Insert the secondary memory into the memory socket.
2.
Press the clips to secure the memory module to the system board.
3.
Place the memory shield in its original position on the computer and tighten the screw to secure it to
the computer.
15
