Installing the palmrest
1.
Align the palmrest on the computer and press on the positions indicated until it snaps in place.
2.
Tighten the screws that secure the palmrest to the computer.
3.
Connect the following cables:
a. security board
b. power-switch cable
c. touchpad
4.
Flip the computer and tighten the screws at the bottom of the computer.
5.
Install the:
a.
b.
c.
d.
e.
6.
After working inside your computer
.
Removing the speakers
1.
Before working inside your computer
2.
Remove the:
a.
b.
c.
d.
e.
f.
3.
Perform the following steps to remove the speaker:
a. Disconnect the speaker cable from the system board [1].
b. Unroute the speaker cable and remove the cable from the routing tabs.
c. Lift the speakers, along with the speaker cable and remove it away from the computer [2].
23
