8.
Starting at the back center of the palm rest, use your fingers to separate the palm rest from the computer base by lifting the inside of the palm rest
while pushing in on the outside.
Installing the Palm Rest
1.
Align the palm rest with the computer base and snap into place.
2.
Connect the touch pad cable to the connector on the system board.
3.
Replace the three M2.5 x 5-mm screws on the top of the palm rest.
4.
Turn the computer over and replace the thirteen M2.5 x 8-mm screws.
5.
Replace the
display assembly
.
6.
Replace the
keyboard
.
7.
Replace the
center control cover
.
Back to Contents Page
1
M2.5 x 8-mm screws (13)
NOTICE:
Carefully separate the palm rest from the computer base to avoid damage to the palm rest.
Summary of Contents for Precision M20
