190
Adding and Replacing Parts
1
Follow the procedures in "Before You Begin" on page 151.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 153).
3
Rotate the hard-drive carrier out of the computer (see "Rotating the Hard-
Drive Carrier Back into the Computer" on page 159).
CAUTION:
Fully-buffered memory modules may become very hot during normal
operation. Ensure that memory modules have had sufficient time to cool before you
touch them.
4
Press out the securing clip at each end of the memory module connector.
5
Grasp the module and pull up to lift the memory module from the
memory riser card.
If a module is difficult to remove, gently ease it back and forth to remove it
from the connector.
6
Rotate the hard-drive carrier back into place (see "Rotating the Hard-Drive
Carrier Back into the Computer" on page 159).
7
Replace the computer cover (see "Replacing the Computer Cover" on
page 161).
Installing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the
Product Information Guide
.
1 memory module
2 securing clip (2)
2
1
Summary of Contents for Precision NX046
