Removing the Memory
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the left cover.
3.
Press down on the memory-securing clips on each side of the memory module, and lift the memory module
upwards to remove it from the computer.
Figure 28.
Installing the Memory
1.
Insert the memory module into the memory socket.
2.
Press down on the memory module until the securing clips secure the memory in place.
3.
Install the left cover.
4.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Coin-Cell Battery
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the left cover.
3.
Press the release latch away from the battery to allow the battery to pop-up from the socket. Lift the coin-cell
battery out of the computer.
Figure 29.
Installing the Coin-Cell Battery
1.
Place the coin-cell battery into the slot on the system board.
2.
Press the coin-cell battery downward until the release latch springs back into place and secures it.
3.
Install the left cover.
4.
Follow the procedures in
After Working Inside Your Computer
.
23
Summary of Contents for Precision Workstation T7600
