5–Preboot Adapter Configuration
Data Center Bridging Configuration
42
BC0154503-00 B
Data Center Bridging Configuration
The data center bridging settings comprise the DCBX protocol and the remote
direct memory access (RDMA) over converged Ethernet (RoCE) priority.
To configure the data center bridging (DCB) settings:
1.
Select
Data Center Bridging (DCB) Settings
in the Main Configuration
Page (
), and then click
Finish
.
2.
In the Data Center Bridging (DCB) Settings page, click the
DCBX Protocol
drop-down, and choose from the following options:
Disabled:
Disables DCB
IEEE:
IEEE protocol
CEE:
Converged Enhanced Ethernet (CEE) protocol
Dynamic:
Dynamically applies CEE or IEEE to match the attached link
partner
3.
In the Data Center Bridging (DCB) Settings window, click the
RoCE Priority
field, and then a type a value from 0–7.
4.
Click
Back
.
5.
When prompted, click
Yes
to save the changes. Changes will take effect
after a system reset.
NIC Partitioning Configuration
To configure the maximum and minimum bandwidth allocations for each
partition:
1.
Select
NIC Partitioning Configuration
in the Main Configuration Page
(
), and then click
Finish
.
2.
In the NIC Partitioning Configuration page, select
Global Bandwidth
Allocation
.
Summary of Contents for QLogic QL45212
Page 100: ......
