Dell Networking SPR-WL2-MNT
| Installation Guide
3
Wall Mounting
This option allows mounting the device on a wall.
Required Tools and Equipment
Two wall-mount brackets
Eight M4 x 8 mm Phillips flat head screws
Wall-mount screws (not included in this package, the type of screw depends on the installation surface)
Suitable screwdrivers (not included in this package)
Wall anchors (optional, not included in this package)
Installation Steps
To install the device on a wall:
1. Fasten the wall-mount brackets over the mounting holes on the sides of the device using the M4 x 8 mm
Phillips head screws and a suitable screwdriver (see
).
Figure 3
Attaching the Wall-Mount Brackets (W-7205)
2. After choosing a location, mark the points on the wall for the mounting holes.
3. Drill the holes and insert wall anchors if needed.
4. Align the holes of the mounting bracket with the holes on the wall (see
).
5. Use the appropriate screws to secure the device.
6. Connect the AC power cord to the rear of the device to power up.
NOTE: The Ethernet ports must be facing down when installing the device on a wall.
