5. Disassembly and Assembly Procedures
S8
Adjust the bracket chassis module, and then u
.
se a
Philips-head screwdriver to tighten 4pcs screws for
locking the bracket chassis module with the panel
(No.1~4 Screw size= M3x5, Torque=5
±0.5
kgfxcm)
S10
S7
Take 1pcs LED key board and 1pcs middle bezel,
then put the middle bezel into a fixture jip to fix the
middle bezel. Tear off the gum on the back of the
board, and then paste the LED board on the correct
position of the middle bezel, then paste 1pcs mylar
tape to cover the LED board as the picture below
shown.
Move the middle bezel with the LED board close to
the panel unit, then assemble the middle bezel with
the front bezel and panel module.
S11
4
1
1
1
Connect the panel lamp cable to the connector of
the panel module. Connect the LED cable to the
connector of the interface board.
Tear off the release paper of the adhesive tape on
the back of the LED cable, then settle and fix the
LED cable on the back of the panel module.
S9
S12
Use a Philips-head screwdriver to tighten 13pcs
screws for locking the middle bezel with the panel
module.
(No.1~13 screw size=M3x5, Torque=5
±
0.5
kgfxcm)
3
11
10
13
12
8
2
9
4
5
7
6
1
