Dell UltraSharp U2719D, Manual

S10

S8

S12

S9

S11

2

Go to contents page

DELL U2719D

Use a Philips-head screwdriver to remove one screw 

for unlocking the USB board unit, then release the 

USB board unit and put it aside.

(No.1 screw size=M3x6, Torque=4

±

0.5

kgfxcm)

S7

1

Tear off 2pcs aluminium foils for unfixing the bracket, 

then tear off 1pcs mylar tape, and then tear off 1pcs 

acetate tape for unlocking the panel lamp cable

. 

Tear 1pcs PVC tape, then use a proper tool to 

release the function key cable from the connector, 

then pull the function key cable high for releasing the 

function key cable as the picture below shown.

Use a Philips-head screwdriver to remove 5pcs 

screws for unlocking the front bezel with the 

assembled unit. 

(No.1~5 screw size=M2x2.7, Torque=3

±0.5

kgfxcm)

3

5

2

4

1

U

.

se a Philips-head screwdriver to remove 2pcs 

screws(left and right) for unlocking the front bezel 

with the panel module, then disassemble the front 

bezel with the unit and put it aside

(No.1~2 Screw size= M3x0.5x4, Torque=3

~4

kgfxcm)

1

2

Tear off the mylar tape on the function key board, 

then use 

a Philips-head screwdriver to tighten 3pcs 

screws for locking the function key board with the 

front bezel.

(No.1~3 Screw size= M2x2.4, Torque=1

±0.2

kgfxcm)

1

2

3