Replacing the Stand Assembly
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
Before Working Inside Your Computer
. After working
inside your computer, follow the instructions in
After Working Inside Your Computer
. For more
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1.
Slide the tabs on the stand assembly into the slots on the back cover.
2.
Lower the stand assembly to lock it into place.
If you have removed the stand base from the stand riser, follow the steps below:
3.
Align the captive thumbscrew on the stand base with the screw hole on the stand riser and tighten it.
4.
Fold the screw handle on the stand base.
Removing the Back Cover
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
Before Working Inside Your Computer
. After working
inside your computer, follow the instructions in
After Working Inside Your Computer
. For more
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Prerequisites
Remove the
stand assembly
.
Procedure
CAUTION: Do not remove the computer cover unless you need to install internal accessories for
your computer.
1.
Slide the release latches to the unlocked position indicated by a circle.
14
Summary of Contents for vostro 23-3340
Page 1: ...Dell Vostro 23 3340 Owner s Manual Regulatory Model W10C Regulatory Type W10C001 ...
Page 7: ...System Setup Options 70 Flashing the BIOS 80 5 Specifications 81 6 Contacting Dell 84 ...
Page 63: ...20 Replace the memory module s 21 Replace the back cover 22 Replace the stand assembly 63 ...
