1.
screws (2)
2. data cable
3. power cable
Replacing the Optical Drive
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
Before Working Inside Your Computer
. After working
inside your computer, follow the instructions in
After Working Inside Your Computer
. For more
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1.
Route the power cable and data cable through the routing guides on the display-panel base.
2.
Align the screw holes on the interposer with the screw holes on the display-panel base.
3.
Replace the screws that secure the interposer to the display-panel base.
4.
Connect the power and data cables to the system board.
5.
Align the screw holes on the optical-drive bracket with the screw holes on the optical drive.
6.
Replace the screws that secure the optical-drive bracket to the optical drive.
7.
Align the tabs on the optical-drive bezel with the slots on the optical-drive assembly and snap it into
place.
8.
Slide the optical-drive assembly into the optical-drive bay until it snaps into position.
Post-requisites
1.
Replace the
I/O bracket
.
2.
Replace the
power-supply diagnostic board
.
3.
Replace the
VESA-mount bracket
.
4.
Replace the
system-board shield
.
5.
Replace the
back cover
.
6.
Replace the
stand assembly
.
39
Summary of Contents for vostro 23-3340
Page 1: ...Dell Vostro 23 3340 Owner s Manual Regulatory Model W10C Regulatory Type W10C001 ...
Page 7: ...System Setup Options 70 Flashing the BIOS 80 5 Specifications 81 6 Contacting Dell 84 ...
Page 63: ...20 Replace the memory module s 21 Replace the back cover 22 Replace the stand assembly 63 ...
