Steps
1. Ensure that the securing-clips are in an open position.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Insert the memory module into the memory-module connector until the memory module snaps into position and the securing
clip locks in place.Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks
into place.
NOTE:
The securing-clips return to the locked position. If you do not hear the click, remove the memory module and
reinstall it.
NOTE:
Repeat step 1 to step 3 when installing more than one memory module in your computer.
Next steps
1. Install the
.
After working inside your computer
.
Hard-drive assembly
Removing the primary 2.5-inch hard-drive assembly
Prerequisites
Before working on your computer
.
2. Remove the
.
3. Remove the
.
24
Disassembly and reassembly
Summary of Contents for Vostro 3881
