Installing the system board
1
Align the screw holes on the system board with the screw holes on the system.
2
Replace the six M2.0 x 2 screws to secure the system board to the computer.
3
Align the screw holes of the USB Type C bracket with the screw holes on the system board and replace the two screws to secure the
bracket to the system.
4
Connect the eDP cable, power adapter port cable and speaker cable to the connector in the system board.
5
Connect the Input output board cable, speaker cable, keyboard backlight cable, keyboard cable and touchpad cable to the system
board.
6
Install the:
a
b
c
d
e
7
Follow the procedure in
After working inside your computer
.
Touchpad
Removing touchpad
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
To remove the touchpad:
a Peel the adhesive from the touchpad.
b Remove the four M2.0 x 2 screws that secure the touchpad to the system [1].
c Disconnect the touchpad cable from the connector in the system [2].
24
Removing and installing components
