d Remove the three M2.0 x 2 screws that secure the touchpad support bracket to the system and lift the touchpad away from
system [1, 2].
Installing touchpad
1
Replace the three screws to secure the touchpad support bracket to the system.
2
Connect the touchpad cable to the connector in the system.
3
Replace the four screws to secure the touchpad to the system.
4
Paste the adhesive to the touchpad.
5
Install the:
a
b
6
Follow the procedure in
After working inside your computer
.
Display assembly
Removing display assembly
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
To remove the display assembly:
a Unroute the WLAN cable [1], and disconnect the eDP cable from the connector in the system board [2].
Removing and installing components
25