Installing the Coin-Cell Battery
1.
Place the coin-cell battery into its slot on the computer.
2.
Route the coin-cell battery cable along the routing channel.
3.
Connect the coin-cell battery cable to its connector on the system board.
4.
Install :
a) battery
b) base cover
5.
Follow the procedures in
After Working Inside Your Computer.
Removing the WLAN Card
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a) base cover
b) battery
3.
Perform the steps as shown in the illustration:
a) Disconnect the antenna cable from the WLAN card.
b) Remove the screw that secures the WLAN card to the computer.
c) Remove the WLAN card from its slot on the system board.
Installing the WLAN Card
1.
Insert the WLAN card into its connector at a 45–degree angle.
2.
Tighten the screw to secure the WLAN card to the computer.
3.
Connect the antenna cables to their respective connectors marked on the WLAN card.
4.
Install:
a) battery
b) base cover
5.
Follow the procedures in
After Working Inside Your Computer.
14
Summary of Contents for Vostro 5470
