3.
Connect the antenna cables to their respective connectors marked on the WLAN card.
4.
Install :
a) battery
b) base cover
c) optical drive
5.
Follow the procedures in
After Working Inside Your Computer.
Removing the System Fan
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a) optical drive
b) base cover
c) battery
3.
Ease the charge-coupled-device(CCD)/woofer cable from it routing channel.
4.
Disconnect the system fan cable from its connector on the system board and remove the screws that secure the
system fan to the system board.
5.
Lift and remove the system fan from the computer.
Installing the System Fan
1.
Place the system fan into its original position in the system board and affix the system board flex cable.
2.
Tighten the screws to secure the fan to the system board.
3.
Route the charge-coupled-device(CCD)/woofer cable.
4.
Install:
a) battery
b) base cover
c) optical drive
5.
Follow the procedures in
After Working Inside Your Computer.
Removing the Heat Sink
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove :
a) optical drive
b) base cover
c) battery
3.
Loosen the screws that secure the heat sink to the system board.
14
Summary of Contents for Vostro 5560
