Steps
1. Align the screw holes on the processor fan and heatsink assembly with the screw holes on the system board.
2. As per the sequential order (1 < 2 < 3 < 4) tighten the four captive screws to secure the fan and heatsink assembly to the
system board.
3. Connect the processor fan cable to connector on the system board.
Next steps
1. Install the
.
After working inside your computer
.
Processor
Removing the processor
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
About this task
The following images indicate the location of the processor and provide a visual representation of the removal procedure.
Disassembly and reassembly
39
Summary of Contents for Vostro 5890
