Steps
1. Align the screw holes on the keyboard with the screw holes on the palm-rest assembly.
NOTE:
Adhere the two conductive tapes on the keyboard, and then adhere the three copper foils on the palm-rest
assembly to secure the keyboard assembly to the palm-rest assembly.
2. Replace the 38 screws (M1.2x1.4) and ten screws (M1.2x1.6) that secure the keyboard to the palm-rest assembly.
NOTE:
Do not install keyboard assembly screws into locations that are marked with MB. Those screw holes are
reserved for system board screws.
3. Adhere the keyboard controller board cable to the keyboard.
4. Connect the keyboard cable and keyboard backlight cable to the keyboard controller board.
5. Adhere the right keyboard bracket in the slots on the palm-rest assembly.
6. Tighten the captive screw that secures the right keyboard bracket to the palm-rest assembly.
7. Adhere the right keyboard bracket in the slots on the palm-rest assembly.
8. Tighten the captive screw that secures the left keyboard bracket to the palm-rest assembly.
9. Route the speaker cable through the routing guides on the left keyboard assembly.
10. Adhere the fingerprint reader cable to the keyboard.
Next steps
1. Install the
2. Install the
.
3. Install the
.
4. Follow the procedure in
After working inside your computer
.
30
Removing and installing components
Summary of Contents for XPS 13 7390 2-in-1
Page 1: ...XPS 13 7390 2 in 1 Service Manual Regulatory Model P103G Regulatory Type P103G001 ...
Page 10: ...10 Removing and installing components ...
Page 11: ...Removing and installing components 11 ...
Page 25: ...Removing and installing components 25 ...
