Extracción de la placa base
AVISO: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
. After working inside your computer, follow the
instructions in
After working inside your computer
. For more safety best
practices, see the Regulatory Compliance home page at
.
NOTA: Your computer’s Service Tag is stored in the system board. You must
enter the Service Tag in the BIOS setup program after you replace the
system board.
NOTA: Replacing the system board removes any changes you have made to
the BIOS using the BIOS setup program. You must make the appropriate
changes again after you replace the system board.
NOTA: Before disconnecting the cables from the system board, note the
location of the connectors so that you can reconnect the cables correctly
after you replace the system board.
Requisitos previos
1
Extraiga la
.
2
Extraiga la
3
Extraiga la
.
4
Extraiga la
.
5
Extraiga el
Procedure
1
Peel off the tape that secures the antenna cables and power-adapter port cable
to the system board.
2
Disconnect the camera cable, touchscreen cable (optional), power-adapter port
cable, and coin-cell battery cable from the system board.
70
Summary of Contents for XPS 13
Page 1: ...XPS 13 Service Manual Computer Model XPS 9360 Regulatory Model P54G Regulatory Type P54G002 ...
Page 27: ...2 Coloque la cubierta de la base 27 ...
Page 32: ...Requisitos posteriores 1 Coloque la batería 2 Coloque la cubierta de la base 32 ...
Page 90: ...Procedure After performing all the pre requisites we are left with the palm rest assembly 90 ...
