5 |
Instruction Manual
5 |
P a g e
6.
Error Codes
Fan Fault\
Possible Electronic Box or compressor fault\
Fan is drawing too many Amps (Over 1 Amp)
The error codes are depicted by a number of flashes by the error light in a sequence every
four seconds.
Code
Reason / Solution
1 Flash
Low Voltage
-
Please check the source voltage to ensure it is above
the cut out. Try lowering the voltage cut out setting to
LOW.
-
The vehicle cabling may be inadequate/unsuitable,
please refer to cable specifications table for correct
cable thickness (Page 2)
-
Try on a different power source
2 Flashes
Fan issue
-
3 Flashes
Compressor Start Issues
-
Unplug for 10 Minutes
-
Try on a different power source.
-
4 Flashes
The compressor speed is too low
-
Unplug for 10 Minutes
-
Reduce product load inside unit
-
Move unit to a lower ambient temperature
-
Clean vents / ensure clear air flow over compressor
5 Flashes
Ambient Temperature too high
-
Clean vents / ensure clear air flow
-
P a g e
