www.dellonda.co.uk 11
• Lock the control panel when you are away to
prevent other people changing your settings.
• Press the massage button to activate the
bubble massage system, the green indicator
light turns on. It can be turned off by pressing
it again.
• Note: The massage system will stop
automatically after 30 minutes of operation.
Re-activate the massage function by pressing
the massage button again.
•
When the filter button is on, pressing the
massage button will turn filter mode into
massage mode: filter indicator light will turn
off and massage indicator light will turn on. If
you press the massage button again, the
massage mode will be changed back to filter
mode.
•
Press the filter button to activate the water
filtration. The green indicator light will turn on
when the filtration system is activated.
•
Note: If massage function is on, the filtration
can’t be activated.
• Press the heater button to activate the water
heating and filtering system at the same time.
The green indicator light of the filter and red
indicator light of the heater will turn on at the
same time.
Control Panel
Functions
• Once powered-up, the
LED
displays the current
water temperature automatically.
• The temperature units selector changes the
temperature units from Celsius to Fahrenheit.
• Press the temperature adjustment buttons,
then the screen will flash. When it
is flashing, you can set the desired
temperature. The value will
increase or decrease 1 degree at a
time. The temperature could be
set between 30°C to 40°C (86°F to
104°F).
• To lock or unlock the control
panel, press the Lock button and
hold 3 seconds.
1
Filtration
2
Heat Button
3
Massage Button
4
Lock Button
5
LED Display
6
Temperature Units Indicator
7
Temperature Decrease Button
8
Temperature Unit Selection
9
Temperature Increase Button
• The pump does not stop heating until the
current water temperature reaches the set
temperature; and the heating system will
restart after the current water temperature
drops 2°C below the set temperature
automatically.
• Maximum heating temperature: 40°C (104°F).
• Important :
•
After 150 cumulative hours of filtration
operations, an audible alarm will sound and
the
LCD
display will show the characters
CHG
,
followed by
FIL
, to remind you to change
or clean the filter. You can hold the filtering
button for 5 seconds to turn off the buzzing.
The filtering system will turn off, you can press
the button to activate the filtering system
again.
• Note : When the heating system is started the
filtration system will start working as well.
• After turning off the heating system, the
filtration system will still work.
•
If the massage function is active, the filtration
and heating functions can not be activated.
Spa Cover and Security
• After each use, the control panel must be
locked and the spa must be covered with
its top cover and it must be attached to the
ground sheet with each safety buckle .
• Always keep the spa cover on to minimize
heat loss during heating of the spa and
between uses (but not while it is being used).
Ensure the cover is fitted tightly, as per these
instructions to maximize insulation. It is
recommended that the cover, when not in
use, should be kept off the ground to retain its
cleanliness (particularly the surface in close
proximity to the water surface). The cover
should be stored in an appropriate location,
where it cannot be damaged, or cause
damage.
• Check the set water temperature and consider
lowering it for the times when the spa will
typically not be in use.
