Electric deep fryer
3
Thank you for choosing this electric deep fryer.To get the best results from your
deep fryer it is advisable to read these instructions before using the appliance.
This is the only way to ensure optimum results and maximum safety.
Installation
•
Before use, check that the appliance has not been damaged during transport.
•
Remove the appliance from the packaging, including any p.o.s.
•
Before use, check that the power supply voltage corresponds to the value
shown on the appliance rating plate.The appliance must always be connected
to a well earthed socket rated at 10A minimum.The manufacturer is not liable
for damage caused by inadequate earthing of the appliance.
•
Before using the deep fryer for the first time, carefully clean the basket, the bowl,
the outer casing and the lid, using warm water and washing up liquid. The control
unit, power cable and heating element may be cleaned using a damp cloth. Check
that water does not enter into the control unit and that there is no residual water
in the bottom of the removable bowl. Carefully dry all the parts.
•
Check that the control unit is properly fastened to the deep fryer body.The safety
micro-switch will not allow the appliance to be operated if the control unit is not
correctly positioned in the casing.
•
Place the fryer on a flat work surface at a safe distance from taps and sinks.
•
The deep fryer is now ready for use.
Thermal safety device
The appliance is fitted with a thermal safety device that stops the appliance from heat-
ing in the event of incorrect use or irregular operation. Once the appliance has cooled,
using a toothpick or something similar, delicately press the safety device reset buttons
marked RESET. If the appliance does not start operating again, contact a service centre
authorised by the manufacturer.
Operating the Control Panel
1.
On/Off Button.
Used to start preheat function and countdown timer.
2.
Temp/Time Button.
Used to change temperature and timer settings.
Temperature and time must be flashing in order to change.
3.
Celsius/Fahrenheit Button.
Used to change display to either setting.
4.
+ (plus) Button.
Used to increase temperature or time while flashing.
5.
- (minus) Button.
Used to decrease temperature or time while flashing.
6.
Heating Light.
Will illuminate during the preheating cycle.Will cycle on and
off during Ready and Cooking to maintain the set temperature.
7.
Mode Button.
Press to change between 4 preset programs.
8.
Power Light.
Will illuminate whenever the unit is plugged in.
9.
Temperature/Time display.
10.
Chip Program Indicator.
11.
Fish Program Indicator.
12.
Chicken Program Indicator.
13.
Shrimp Program Indicator.
14.
Heating Indicator.
Will flash while unit is preheating.
15.
Ready Indicator.
Will flash when preset temperature has been reached.
Fryer will maintain temperature displayed when ready indicator is flashing.
16.
Cooking indicator.
Will flash when preset temperature has been reached
and countdown timer is being used.
Summary of Contents for F14427CZ
Page 12: ...418IDL 04 05 ...
