34
230 V
L1
N(L
2
)
PE
✓
The power supply cord must not touch against any hot surfaces
and must be placed so that its temperature does not exceed
75°C at any point along its length.
✓
After having installed the appliance, the power switch or power
plug must always be in a accessible position.
✓
The appliance must have its own supply; any other appliances
installed near it must be supplied separately.
✓
N.B. For connections to the mains power supply, never use
adaptors, reductions or multiple power points as these may
overheat and catch fire.
✓
In the event that installation should require modifications to the
mains supply wiring system or if the power plug is not suitable
for the type of power point available, it is recommended that a
qualified technician be called to carry out substitution. The tech-
nician will also have to verify that the cross-section of the elec-
tric cables on the power point match the appliance’s power
rating.
FEEDER SPECIAL CABLE SECTION
Type “HO5V2V2-F”
resistance to temperatures of 90°C
230 VAC 50 Hz
3 x 0,75 mm
2
230 VAC 50 Hz
3 x 1 mm
2
(for models with a rating of 1,5 kW at 230 V)
✓
The supply cable must be replaced with a cable of the same
type.
✓
The electrical cable must be connected to the terminal board
following the diagrams of Fig. 6.3.
Fig. 6.3
