Page 14
Page 15
STEP 03
Mounting assembly to sink flange
Working from underneath sink, slip the
1.
metal backup ring, flat side up, over sink
flange.
Hold backup ring in place as you slip
2.
tapered ring over sink flange so it settles
against backup ring.
Hold backup ring and slope ring tight
3.
against sink bottom. Slide snap ring onto
sink flange until it pops into groove on
flange.
Tighten three mounting screws into sink
4.
until mounting assembly is seated tightly
and evenly against sink.
HINT: Placing a thick, wide rubber band around
the sink flange (above the snap ring groove)
may help hold parts in place while installing
snap ring. Remember to remove rubber band
after snap ring is installed.
STEP 04
Clean sink drain line
Failure to clean sink drain line may result in
drain line blockage.
Remove drain trap.
1.
Flush the piping with water to clear away
2.
all residue and waste in horizontal drain
line.
Installing Your Waste Disposer
Installing Your Waste Disposer
STEP 01
Disassemble new disposer mounting
assembly
Turn mounting assembly over and loosen
1.
three mounting screws until snap ring is
accessible.
Use screwdriver to pry off snap ring from
2.
sink flange. Mounting assembly will now
come apart.
STEP 02
Install flange in sink hole
Insert sink flange into sink gasket.
1.
Insert sink flange with sink gasket
2.
component into the sink.
