Keep the appliance at a distance or at least 50 cm from inflammable objects and substances.
The socket used by this appliance must be outside areas where the presence of water could
represent a source of risk (fig. 3).
Proceed as follows:
• Identify the most suitable location to install the appliance, respecting safety distances from sur-
rounding materials and in such a way that the electrical disconnecting devices are easily
accessible;
• Fix the "
D
" brackets respecting the distances indicated in fig.1:
• Hang the towel warmer on the two brackets previously fixed to the wall. Mark the positions of
the remaining fixing points on the wall ("
B
" only for the single version SCW100, "
B
" and "
C
"
for the double version SCW200);
• Remove the towel warmer, drill the wall and insert the anchors.
• Re-hang the towel warmer on the brackets and fix it with the screws supplied, then fit the cov-
ers provided (fig.2);
• The appliance must not be installed immediately under a fixed socket.
D.
Bracket
E.
"
ON
" indicator light
F.
"
Timer on
" indicator light
G.
"
P1
" programme
H.
"
P2
" programme
I.
"
Mode
" button
L. “Clock
set”
button (setting time)
1. Setting the clock
When connected to the mains for the first time or each time mains power comes back on,
“
0000::0000
” flashes on the display.
It is now possible to set the clock by pressing the “
Clock Set
” button and proceeding as follows:
•
single pressure of the "Clock set" button
the clock goes forward
one
minute;
•
first 20 secs of continuous pressure
the clock goes forward
slowly
;
•
uous pressure after 20 secs
the clock goes forward fast.
Once setting has been completed, the flashing continues for several seconds, then indicates the
exact time steadily. The clock starts operating.
To set the clock again, just hold the "
Clock set
" button down for several seconds until the time
display starts to flash The time can now be set following the instructions described above.
2
DESCRIPTION
OPERATION AND USE
