Vacuum cleaner operation
Mod. WF1500E
• To use the appliance as a vacuum cleaner, a
minimum of 2.5 litres of water should be
poured into the tank; do not exceed the
maximum level of 4 litres marked on the tank.
Mod. WF1300ES
• To use the appliance as a vacuum cleaner,
pour 2.5 litres of water into the tank,
corresponding to the MAX level marked on the
tank.
The suction conveyor
J
can be removed to
simplify filling the tank, (Fig. 4).
The water has the function of filtering the dust,
and stopping it from spreading in the
environment.
Wet vacuuming operation
When using the appliance as a wet vacuum
cleaner, up to 9 litres of water can be held in the
tank for the WF1500E models, and up to 6 litres
for the WF1300ES models.
If this maximum limit is exceeded, the safety float
U
is activated and the appliance will stop
vacuuming. In this case, empty the tank, remove
the filter from the float, dry it and then put it back
in place.
Please note: To use the appliance as a wet vacuum
cleaner after having used it as a vacuum cleaner,
the tank does not need to be emptied, even if this
operation can be performed without water.
• Replace the tank on the trolley
Q
, position the
motor head in place and raise the handle that
blocks the motor head, until it clicks into place.
• Fit the hose
G
to the appliance, inserting the
end with the bayonet into the inlet port
E
and
then turning it clockwise (Fig. 5).
To remove it, simply turn it anticlockwise.
• Fit the telescopic tube
K
onto the hose grip,
pushing it fully into place.
• Fit the accessory required for the operation
being performed to the telescopic tube K or
directly to the hose grip
G
.
ACCESSORIES
“Explora”
carpet/floor brush (some models
only):
Cleans dust efficiently from both hard
floors or mats and carpet.
Thanks to the articulated
fins, this model is
particularly suited to
cleaning right up close to
furniture and into corners.
For cleaning wider areas,
simply rotate the brush to
use the total width.
Accessory for delicate floors of the “Explora”
brush (some models only)
The accessory features
felt strips for using the brush on delicate surfaces
such as parquetry and treated marble.
To fit the accessory to the
base of the “EXPLORA”
brush, line up the two pins
on the accessory with the
two holes on the bottom of
the brush and press until it
clicks into place.
6
fig. 4
fig. 5
GB 26-11-2002 11:31 Pagina 6
