6
Using the PN-60
For information on setting up your device for the fi rst
time, see the
Quick Start Guide
.
Batteries and SD Card
Use two AA batteries (Lithium is recommended;
you can also use NiMH or alkaline) or a DeLorme
rechargeable Lithium-ion (Li-ion) battery.
When the PN-60 is using battery power, the battery
indicator on the Home Page displays the percentage
of battery life remaining.
Remove the batteries when storing the PN-60 for
a month or longer.
A slot for an SD card (not included) is underneath
the batteries inside the battery compartment.
SD/SDHC/MMC cards up to 32GB are supported.
To install batteries and the SD card
1. Unscrew the D-rings on the back of the device
until you can remove the battery cover.
2. Optional. To insert an SD card, gently press down
the SD card latch, insert the card in the slot, and press
down the slot to close the latch.
Note
Do not lift
the SD card latch as this could cause damage.
3. Insert the batteries according to the polarity symbols
inside the battery compartment.
4. Replace the back cover and screw in the D-rings.
To check the battery type
After you install the batteries, go to
Settings > System
> Battery Type
and make sure the correct battery type is
selected; this ensures that the battery indicator displays
the correct amount of battery life remaining.
To view the battery indicator
The battery indicator is on the Home Page; for more infor-
mation, see
The Home Page
section on page 16.
To charge a DeLorme Li-ion battery
in the PN-60
1. Install the battery in the device.
2. To leave the device powered on while charging, power
it on and connect the USB cable to the computer. On
the Home Page, the battery indicator displays a plug.
OR
To put the device in charging mode, power it off,
connect the USB cable to the computer, and then
quickly press
Power
. The light indicator below the
Using the PN-60
Summary of Contents for Earthmate GPS PN-60
Page 1: ...Earthmate PN 60 GPS DELORME User Manual ...
Page 5: ......