Page 4
TITAN I
User manual
fig.6
2. Speed calibration
1.
Set the AUTO/MANUAL switch to MANUAL which is placed on the rear side
of the turntable. Fig 6
2.
Push the selection speed 33 button ( for regulating speed 33 rpm ) or 45 (
for regulating the speed 45 rpm ) for more than ten seconds to enter to the
set-up process speed. In this mode the indicator light is blinking, Fig.7
3.
Press momentarily on the following button 33 rpm, repeatedly to increase
the speed (+).
4.
Press momentarily on the following button 45 rpm, repeatedly to decrease
the speed ( – ).
5.
Until it is set. (In this mode we use a strobe disc).
6.
Then press the 33 button (or 45 for regulating the speed 45 rpm) until the
indicator stops flashing to save the setting speed.
7.
Set the AUTO/MANUAL switch to AUTO.
8.
In AUTO position the speed is automatically controlled at real time with
micro sensor under the platter, starting from the speed which is saved in
manual position.
Delta Audio 2014/5
fig.7