59
58
7.5 Incoming calls
(only for the
TTRTC TYXAL+ transmitter)
Ê
Enter the installer code (123456, by default) and confirm with OK.
Ë
Press Settings, then select the menu:
Installation > Products > Configure
Ì
Press the button of the transmitter or select it from the list of products by clicking on
"Browse".
Í
Select the menu "Incoming calls", then:
Î
Number of rings: Specify the number of rings
required before the transmitter picks up the line.
Dual call: You can activate or deactivate the
"rapid" line pick up method.
Rapid line pick up:
- Call the transmitter,
- After 2 rings, hang up,
- Wait for 10 seconds, then call again,
- The transmitter picks up immediately.
7.6 SIM card
(only for the TTGSM TYXAL+ transmitter)
Ê
Enter the installer code (123456, by default) and confirm with OK.
Ë
Press Settings, then select the menu:
Installation > Products > Configure
Ì
Press the button of the transmitter or select it from the
list of products by clicking on "Browse".
Í
Select the "SIM card" menu.
Î
Enter the parameters of the SIM card:
PIN code
PUK code
7.4 Remote monitoring
Ê
Enter the installer code (123456, by default) and confirm with OK.
Ë
Press Settings, then select the menu:
Installation > Products > Configure
Ì
Press the button of the transmitter or select it from the
list of products by clicking on "Browse".
Í
Select the "Remote monitoring" menu.
Î
Protocol selection
You can choose from the following:
- No, Contact ID P10 to P13, CESA 200 P0 to P2
If the CESA protocol is selected, you can change the
pre-programmed loop numbers:
(see § Personalising the transmitter's operation)
Main number
Specify the main number supplied
by the remote monitoring operator.
Emergency number
Specify the backup number supplied by the
remote monitoring operator.
Identifier
Specify the identifier supplied
by the remote monitoring operator.
Cyclic test
The cyclic test is done at regular intervals.
These intervals are programmed:
- either in number of 1/2 hours,
- or for a specific timetable (1 test/24h).
This menu is used to configure the settings for the remote monitoring. A detailed description of the remote
monitoring settings is available in § Remote monitoring appendix
4
5
PSTN transmitter
Incoming calls
Ok
Return
Auto attendant
Identifier
Cyclic test
Remote monitoring
Ok
Return
Protocol selection
Main number
Emergency number
Main number
Ok
0
Return
Emergency number
Ok
0
Return
Identifier
Ok
0
Return
Programming
loop?
Yes
No
Loop list
Ok
Tamper alarm
Technical defect
Return
Intruder alarm
Protocol selection
No >
Return
Ok
Protocol selection
No >
Return
Ok
Remote monitoring
Loop number
Ok
0
Return
Cyclic test
< 1/2 hour
Ok
Return
Cyclic test
Hourly
>
Return
Ok
Hourly
Ok
Return
12
.00
Number of 1/2 hour
Ok
0
Return
This menu is used to determine the number of rings before the line is taken by the transmitter
(only for the TTRTC TYXAL+).
Another method known as "Dual call", enabling rapid line pick up, can be enabled or disabled.
This menu is used to enter the PIN code of the SIM card to activate it.
7. Personalising the transmitter
Summary of Contents for TTGSM TYXAL+
Page 230: ...230 ...
Page 231: ...231 ...
