ASDA-B2
Chapter 6 Control Modes of Operation
Revision September 2013
6-41
6.5.2 Speed / Torque Control Mode Selection
S-T Mode:
The speed command can be the external analog voltage or internal parameters (P1-09
to P1-11) and SPD0~1 is used to select speed command. The same as speed
command, the torque command can be the external analog voltage or internal
parameters (P1-12 to P1-14) and TCM0~1 is used to select torque command. The
speed and torque mode switching is controlled by the S-T signal.
The timing chart of speed / torque control mode selection is shown as the figure below:
In torque mode (when S-T is ON), torque command is selected by TCM0~1. When
switching to the speed mode (when S-T is OFF), the speed command is selected by
SPD0~1, and then the motor will immediately rotate following the command. After S-T
is ON again, it will immediately return to torque mode.
6.5.3 Torque / Position Control Mode Selection
PT-T Mode:
The command source of PT-T mode is from external input pulse. The torque command
can be the external input pulse or internal parameters (P1-12 to P1-14). The torque
and position mode switching is controlled by T-P signal.
The timing chart of speed / position control mode selection is shown as the figure
below:
\
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
