Chapter 7 Servo Parameters
ASDA-B2
7-52
Revision September 2013
Control
Mode:
ALL
Unit: N/A
Range: 0 ~ 65535
Data Size: 16-bit
Display
Format:
Decimal
Settings:
Special parameter setting:
Parameter
code
Function
10
Parameter reset (Please re-power on the
servo drive after reseting)
20
Set P2-08 to 20 can change the value of
P4-10
22
Set P2-08 to 22 can change the value of
P4-11~P4-19
406
DO mode will be forced to be activated.
400
When force to activate the DO mode, set
P2-08 to 400 can switch the mode back to
normal DO mode.
Password protective setting for protecting the parameter from the end-users:
1. After enter the 5 digital numbers, please enter the same password again. And
the setting shall be finished.
2. When turning on the power again, the proctective password will be activated.
Parameter setting after setting up the password:
When entering the correct password, the parameter can be set.
Clear the password: After entering the correct password, please enter “0” twice
continuously.
P2-09
DRT Bounce Filter
Address: 0212H
0213H
Operation
Interface:
Keypad/Software
Communication
Related Section: N/A
Default:
2
Control
Mode:
ALL
Unit: 2ms
Range: 0 ~ 20
Data Size: 16-bit
Display
Format:
Decimal
Input Value
Example:
4 = 8 ms
Settings:
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
